Lightweight at Only 2.6 Ounces
Rycote Lyre Suspension System
Requires 2.5V Camera Plug-in Power
Integrated Shoe Mount with 3/8" Thread
3.5mm Mini-Jack Output
Foam Windshield Included
Reinforced ABS Construction
3.5mm Coiled Output Cable Included
The VideoMic GO On-Camera Shotgun Microphone from Rode is a lightweight microphone which adds high-quality audio recording to your small camcorder and HDSLR camera. At only 2.6 ounces, the microphone keeps your camera setup lightweight, making it ideal for handheld shooting. It features an integrated Rycote Lyre shock mount for isolation from bumps and vibration, and offers battery-free operation, using instead the plug-in power from your camera's 3.5mm microphone input. Please note that the microphone will not work with cameras that don't supply plug-in power to their 3.5mm audio input jack.
The VideoMic GO is a directional microphone. It utilizes a super-cardioid polar pattern to attenuate sounds from the sides, resulting in a signal that sounds closer to the camera, even when shooting in noisy environments or at moderate distances. The integrated shoe mount provides a 3/8" thread for additional mounting options. A foam windshield and 7.9" dual mono 3.5mm coiled output cable.
The VideoMic GO is compatible with the Nikon D4, D800, D600, D7100, D5200, D5100, D3200, Coolpix A, P7800, Nikon1 V2. It is also compatible with the Canon T2i, T3i, T4i, T5i, 60D, 70D, 7D, 6D, 5D Mk II, and 5D Mk III.
It is not compatible with the Nikon D7000.
At only 2.6 ounces, the VideoMic GO is ideal for run-and-gun HDSLR recording without the additional weight of larger on-camera microphone options.
Integrated Rycote Lyre Shock Mount
Constructed from a single piece of hard-wearing thermoplastic, the Lyre provides superior acoustic suspension to traditional elastic solutions, and won't wear out, sag, snap, or require any rethreading to maintain its effectiveness.
No Battery Needed
The VideoMic Go does not require batteries for operation, but instead uses the plug-in power supplied via your camera's 3.5mm microphone input. Simply plug in, and you're ready to record.
Reinforced ABS construction
Integrated shoe mount with 3/8" thread
3.5mm TRS mini-jack audio output connection
Acoustic Principle Line Gradient
Active Electronics JFET impedance converter with bipolar output buffer
Polar Pattern Supercardioid
Address Type End
Frequency Range 100Hz - 16kHz
Maximum SPL 120dB SPL (@ 1kHz, 1% THD into 1KΩ load)
Sensitivity -35.0dB re 1 Volt/Pascal (17.80mV @ 94 dB SPL) +/- 2 dB @ 1kHz
Equivalent Noise Level (A-weighted) 34dB-A
Dimensions 79.00mmH x 73.00mmW x 167.00mmD
Output Minijack Output
Warranty 1 year with free extension to 2 years following registration here